WB-10 Classic Fuel Cleaning System

	Wall Mounted Models		Mild Steel Enclosure Models		Portable Models
WB-10 10 lit/min Power Options	12v DC, 24v DC, 220v 50hz 1ph AC			12v DC, 24v DC, 220v 50hz 1ph AC		12v DC, 24v DC, 220v 50hz 1ph AC

Need help selecting the right system for your requirements? Use our new Product Selector.

For more technical information, please see the Technical Details tab.

*Please note, the dimensions, weights above are for the wall mounted version. The enclosure revision will be slightly larger and heavier. 

**Flow rates quoted assume the ideal conditions, a large positive head, no left, wide pipe work, etc. Narrow pipes, tight bends, elbows, lifts and other such external factors can and will impact on the maximum flow achieved by the system.

The WB range of products is typically wall mountable and should be installed close to the fuel tank it is cleaning.

In any typical fuel tank, the pipe feeding fuel to the engine is not at the bottom, however to successfully clean fuel, the pickup pipe going to the WB unit should be right at the bottom of the tank, below the engine feed.

The return pipe from the WB unit should ideally be at the top of the tank at the opposite end to the pick up; if this is not possible the top of the tank at the same end is acceptable.

Apart from that, the list below highlights our recommendations.

• A fused spur is required to power the system (24v DC or 220v 50hz 1ph AC).
• Only two pipes are required (input/pickup and output/return)
• We recommend a non return valve on the input pipe
• Alternatively we recommend a foot valve at the tank end of the input pipe
• We recommend isolating ball valves before and after the system 
• See the product support page for more information.

• WB Range
• WB-25
• WB-40
• W-PFS Fuel Cleaning Range
• Compare WB and W-PFS
• Use our helpful product selector
• New to fuel polishing?
• How does it work?
• Spare Parts Page
• Product Support
• Download the WB Range brochure
• Fuel polishing Add-ons